Fe esaslı Ti+ Ni3+ Al+ Al2O3 takviyeli kompozitte mekanik alaşımlama yönteminin etkisi
Yükleniyor...
Dosyalar
Tarih
2019
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Namık Kemal Üniversitesi
Erişim Hakkı
info:eu-repo/semantics/openAccess
Özet
Makine Mühendisliği Ana Bilim Dalı Yüksek Lisans Tezi olarak hazırlanan bu çalışmada, toz metalürjisi yöntemi ile titanyum, nikel, alüminyum ve alüminyum oksit takviyeli, demir matrisli kompozitler üretildi. Üretilen kompozitlerin metalografik özellikleri belirlendi. Üretim yapılmadan önce literatürde bulunan benzer çalışmalar araştırıldı ve elde edilen sonuçlar incelendi. Yapılan araştırmalar sonucunda kompozitlerin üretim esnasında basınç ve sıcaklık değerleri belirlendi. Kompozitlerin mikro yapılarının analizi için taramalı elektron mikroskobu(SEM), EDS, XRD, Optik ve Mikrosertlik analizleri kullanıldı. Sonuç olarak üretim aşamasında kullanılacak yöntemler ve değerler belirlenmiş olup elde edilen sonuçlar hakkında bilgi verilmiştir.
In this study, which was prepared as a Master Thesis, Mechanical Engineering Department, titanium, nickel, aluminum and aluminum oxide reinforced iron matrix composites were produced by powder metallurgy method. Metallographic properties of composites were determined. Similar studies in the literature were investigated before the production and the results were examined. As a result of the researches, the pressure and temperature values of the composites were determined during the production. Scanning electron microscopy (SEM), EDS, XRD, optical and microhardness analysis were used for the analysis of microstructures of composites. As a result, the methods and values to be used in the production stage were determined and information about the results was given
In this study, which was prepared as a Master Thesis, Mechanical Engineering Department, titanium, nickel, aluminum and aluminum oxide reinforced iron matrix composites were produced by powder metallurgy method. Metallographic properties of composites were determined. Similar studies in the literature were investigated before the production and the results were examined. As a result of the researches, the pressure and temperature values of the composites were determined during the production. Scanning electron microscopy (SEM), EDS, XRD, optical and microhardness analysis were used for the analysis of microstructures of composites. As a result, the methods and values to be used in the production stage were determined and information about the results was given
Açıklama
Anahtar Kelimeler
Metalürji, Toz metalürjisi, Basınç, Sıcaklık, İmalat, Üretim, Matris, Takviye, Metallurgy, Powder metallurgy, Pressure, Temperature, Manufacturing, Production, Matrix, Reinforcement
