Ara
Toplam kayıt 14, listelenen: 1-10
Single Layer Drying Behavior of Apple Slices in a Microwave Dryer
(Trans Tech Publications Ltd, 2011)
In this study, the drying behaviour of single layer apple slices of 5mm thickness in a microwave dryer was investigated experimentally for four different microwave power levels (90 W, 180 W, 360 W and 600 W) and suitability ...
Simulation of Drying Behavior of Cotton Bobbins by a Simultaneous Heat and Mass Transfer Model
(Trans Tech Publications Ltd, 2011)
In this study, the drying process of cotton bobbins for different drying air temperatures has been simulated by a simultaneous heat and mass transfer model. In the model, the mass transfer is assumed to be controlled by ...
Drying Behavior of Polyester Based Yarn Bobbins in a Hot-Air Bobbin Dryer
(Trans Tech Publications Ltd, 2011)
Drying behavior of polyester based yarn bobbins (67% polyester, 33% viscose) was simulated for different drying air temperatures by a simultaneous heat and mass transfer model. In the model, it was assumed that mass transfer ...
Failure Behavior of Corrugated Core Panel Under Out-Of-Plane Loading
(Aalborg Univ Press, 2015)
The aim of this study is to investigate the failure behaviour of a panel with a novel corrugated core design under out-of-plane loading conditions. AS4/8552 prepreg system was used for both facesheet and core material and ...
Investigation of the effect of drying air temperature on drying time by numerical method for textile bobbins
(Institute of Physics Publishing, 2019)
Drying of the yarn bobbins in the textile sector is a very important stage among the textile finishing processes. Because this process takes a lot of time and causes a large amount of energy consumption. In this study, ...
Bending and compression performance of composite tube reinforced foam core sandwich structures
(Applied Mechanics Laboratory, 2020)
In some applications such as walls and roofs, it is important to supply low thermal conductivity and high bending stiffness to structures. Generally, foam materials are preferred, which have low thermal conductivity. ...
Quantifying the delamination of L-shaped composite laminates under low velocity impact using x-ray computed tomography
(DEStech Publications Inc., 2018)
Low velocity impact response and failure behavior of L-shaped composite laminates were investigated. The composite laminates with variable thickness, stacking sequences, and corner radius were manufactured using autoclave ...
Design of a real-sized composite drive shaft and critical points from beginning to end
(Applied Mechanics Laboratory, 2020)
In this study, the replacement of a metal drive shaft by a composite counterapart was investigated. The drive shaft considered here is a thin walled tube with an internal diameter of 60 mm and a length of 1200 mm. These ...
Research on the fire endurance of the silica sand membrane
(Institute of Physics Publishing, 2019)
In this study, the fire endurance, density, low-temperature deflection, penetration and ring-ball method tests of the membrane produced throughout the mixing of Bitumen, IPP (isotactic polypropylene), LDPE (Low-density ...
Micromechanical modeling of particulate-filled composites using X-ray computed tomography
(DEStech Publications Inc., 2017)
Glass fillers with different shape and mass fractions were considered to demonstrate the wide range of applicability of micro-CT imaging. It is shown that micro-CT technique can be used to create realistic RVEs for two-phase ...