Ara
Toplam kayıt 710, listelenen: 601-610
Effect of bimetallic (Ni and Co) substitution on magnetic properties of MnFe2O4 nanoparticles
(Elsevier Ltd, 2016)
Nickel and cobalt substituted manganese ferrite nanoparticles (NPs) with the chemical composition NixCoxMn1–2xFe2O4 (0.0?x?0.5) NPs were synthesized by one-pot microwave combustion route. The effect of co-substitution (Ni, ...
Preparation and characterization of PVDF-based nanocomposites
(wiley, 2014)
Energy is of great importance in our lives. There might have been a time when people lived without it, but now, after we all got used to having it, it is almost impossible to survive without the energy. However, the energy ...
ISO 9164 heat loss in roof-wall sections
(Academic Journals, 2011)
In the simple ISO 9164 calculation procedure for transmission heat loss coefficient, HT, it is unclear, and undefined for floor or roof-wall sections, how the parameters in the equations will be calculated. In this paper, ...
Tourmaline nanoparticles doped polyvinylidene fluoride (PVDF) nanofibers
(Kauno Technologijos Universitetas, 2019)
The aim of this work is to produce tourmaline (TM) doped polyvinylidene fluoride (PVDF) nano-composite fibers. TM-containing PVDF nanofibers were produced via a horizontally located electrospinning unit. N,N-dimethylformamide ...
Experımental analysıs of the thermal behavıour of mezzanıne floors ın buıldıngs wıth cavıty wall ınsulatıon
(Academic Journals, 2010)
In this study, the thermal behaviour of mezzanine beam-slab floor sections of buildings under temperate climate conditions was experimentally investigated. Data were obtained from measurements on buildings under service ...
An investigation on the effect of bottom layer material on the voltage output of a piezoelectric smart woven structure
(Ege Universitesi, 2018)
In this work, the voltage output of a 2-dimensional (2D) woven fabric produced by using polyvinylidene fluoride-based (PVDF) piezoelectric filaments into a plain woven fabric structure was studied. PiezoelectricPVDF filaments ...
The effect of core-sheath proportion on the characteristics of hollow yarns: part I mechanical properties
(Taylor and Francis Ltd., 2018)
In the scope of this study, core yarns in the yarn count of 59 tex were produced by using cotton, viscose, wool, and polyester fibers in the sheath and different ratios of polyvinyl alcohol (PVA) in the core. After completion ...
Design of a real-sized composite drive shaft and critical points from beginning to end
(Applied Mechanics Laboratory, 2020)
In this study, the replacement of a metal drive shaft by a composite counterapart was investigated. The drive shaft considered here is a thin walled tube with an internal diameter of 60 mm and a length of 1200 mm. These ...
A novel approach for composite wear plate fabrication by using vertical centrifugal casting
(Kauno Technologijos Universitetas, 2018)
A novel approach of wear plate fabrication by vertical centrifugal casting was proposed and demonstrated in this paper. Wear plates were reinforced by the addition of M7C3 carbide particles during vertical centrifugal ...
Sigmoid based PID controller implementation for rotor control
(Institute of Electrical and Electronics Engineers Inc., 2015)
This paper presents a sigmoid based variable coefficient PID (SBVC-PID) controller design for Twin Rotor MIMO System (TRMS). The proposed SBVC-PID controller dynamically changes controller coefficients according to a ...