Ara
Toplam kayıt 3954, listelenen: 3731-3740
Evaluation of factors affecting bulk Chlorine decay kinetics for the Zai water supply system in Jordan. Case study
(Technical University of Wroclaw, 2017)
Chlorine decay behavior is significantly variable since it depends on the quality of water and the condition of a distribution system. The effect of various parameters on the bulk chlorine decay kinetics in water samples ...
Permeability properties of single jersey fabrics made of hollow yarns
(Taylor and Francis Ltd., 2017)
In this work effect of using hollow yarns on the permeability properties of the single jersey knitted fabrics were studied. Firstly yarns were produced by ring spinning machine using cotton, viscose and acrylic fibres in ...
Cyclic loading tests of sub-standard RC frames retrofitted with buckling restrained braces and elastic steel frames
(Architectural Institute of Japan, 2016)
Strength and stiffness of panel and joint in non-diaphragm CHS-column to H-beam connection were experimentally investigated Herein, the panel means the cylindrical stub circumscribed by outer planes of the beam and the ...
Photocatalytic degradation of cefazolin over N-doped TiO 2 under UV and sunlight irradiation: Prediction of the reaction paths via conceptual DFT
(2012)
Cefazolin is a semi-synthetic antibiotic found in aqueous environments as a pollutant due to its widespread use. The photocatalytic degradation of cefazolin was investigated in aqueous N-doped and undoped-TiO 2 suspensions ...
Enhanced solar photocatalytic activity of TiO2 by selenium(IV) ion-doping: Characterization and DFT modeling of the surface
(2013)
TiO2 was doped with Se(IV) ions to obtain a visible light active photocatalyst with high photocatalytic activity. In order to characterize and describe the effect of Se(IV)-doping on the electronic and structural properties ...
Response surfaces for compressive strength of concrete
(2013)
The aim of total quality management (TQM) is to offer satisfactorily high quality products to customers for providing increased productivity and decreased costs. Various methods are used for process improvement, development ...
Spatial evaluation of primary sugar factories in early republican period in Turkey
(Istanbul Teknik Universitesi, Faculty of Architecture, 2017)
During the early republican period of Turkey, new industrial complexes were emerged through modernity project and modern architecture. One of this industrial complexes were the sugar factories with their production and ...
Effect of bimetallic (Ni and Co) substitution on magnetic properties of MnFe2O4 nanoparticles
(Elsevier Ltd, 2016)
Nickel and cobalt substituted manganese ferrite nanoparticles (NPs) with the chemical composition NixCoxMn1–2xFe2O4 (0.0?x?0.5) NPs were synthesized by one-pot microwave combustion route. The effect of co-substitution (Ni, ...
ISO 9164 heat loss in roof-wall sections
(Academic Journals, 2011)
In the simple ISO 9164 calculation procedure for transmission heat loss coefficient, HT, it is unclear, and undefined for floor or roof-wall sections, how the parameters in the equations will be calculated. In this paper, ...
A new methodology for the determination of enzyme activity based on carbon nanotubes and glucose oxidase
(Elsevier, 2015)
In this research, a novel enzyme activity analysis methodology is introduced as a new perspective for this area. The activity of elastase enzyme, which is a digestive enzyme mostly of found in the digestive system of ...