Comparison of finite element analysis results with strain gauge measurements of a front axle housing

Basit Öğe Kaydı
dc.authoridGUR, Yilmaz/0000-0003-1709-1298
dc.contributor.authorGur, Yilmaz
dc.contributor.authorCen, Goekhan
dc.date.accessioned2024-10-29T17:59:45Z
dc.date.available2024-10-29T17:59:45Z
dc.date.issued2024
dc.departmentTekirdağ Namık Kemal Üniversitesien_US
dc.description.abstractThe strength of the front axle of tractors used on rough terrain is crucial in countries in which agriculture is widespread. Rough agricultural fields, rugged village roads, and ground irregularities cause unexpected reaction forces on the axles. Thus, it is important to analyze the front axle of a tractor with respect to stress, which eventually leads to cracks and premature failure. In this study, ANSYS 13.0 finite element analysis (FEA) software (ANSYS, 2010) was used to predict the strength of a design under loading conditions. ANSYS 13.0 allows products to be tested in a virtual environment and helps to prevent problems that may arise later and accordingly improve them. This study aims to investigate the stresses that occur on the housing of the front axle of a tractor. The reaction forces acting on the front axle housing can cause cracks near the middle of the housing. The study applies a static load of 30 000 N to both hubs at the end of the front axle housing and uses the FEA method to predict and evaluate the maximum stress areas on the housing. Strain gauges are bonded to these locations to measure the real-life stresses on the axle housing in these areas. The results of the FEA and strain gauge measurements were compared, and a correlation was found with 98 % accuracy.en_US
dc.identifier.doi10.5194/ms-15-257-2024
dc.identifier.endpage268en_US
dc.identifier.issn2191-9151
dc.identifier.issn2191-916X
dc.identifier.issue1en_US
dc.identifier.startpage257en_US
dc.identifier.urihttps://doi.org/10.5194/ms-15-257-2024
dc.identifier.urihttps://hdl.handle.net/20.500.11776/14830
dc.identifier.volume15en_US
dc.identifier.wosWOS:001206195700001en_US
dc.indekslendigikaynakWeb of Scienceen_US
dc.language.isoenen_US
dc.publisherCopernicus Gesellschaft Mbhen_US
dc.relation.ispartofMechanical Sciencesen_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectSpectrumen_US
dc.titleComparison of finite element analysis results with strain gauge measurements of a front axle housingen_US
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu